Rear - Single Rear Wheels (SRW)

REAR BRAKE ROTOR - (SINGLE REAR WHEELS) (SRW)





1. Install the disc brake rotor (3) to the hub and install the locking bolt (1) for the rotor. Tighten to 22 Nm (194 in. lbs.).
2. Install the disc brake caliper adapter. Tighten to 80 Nm (59 ft. lbs.) Plus an additional 40° turn.
3. Adjust the parking brake
4. Press and release the brake pedal several times until pressure has built up.
5. Check fluid in reservoir and correct if necessary.
6. Install the rear wheels.
7. Lower the vehicle.