Front - Single Rear Wheel (SRW)

FRONT BRAKE ROTOR - SINGLE REAR WHEEL (SRW)





1. Install the disc brake rotor (3) to the hub and install two lug studs (2) to hold rotor in place.
2. Install the locking bolt (1) for the rotor (3). Tighten to 22 Nm (194 in. lbs.).




3. Install the disc brake caliper adapter (1) and the caliper (4) assembly. Tighten the adapter bolts (1) to 80 Nm (59 ft. lbs.) Plus an additional 40° turn.
4. Press and release the brake pedal several times until pressure has built up.
5. Check fluid in reservoir and correct if necessary.
6. Install the front wheels .
7. Lower the vehicle.