Wiper Motor - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm and blade (1) from the rear wiper motor output shaft..
3. Remove the lower trim panel (7) from the inside of the rear door..
4. Disconnect the vehicle wire harness connector (2) from the rear wiper motor (5).
5. Disconnect the washer hose (3) from the fitting on the motor.
6. Remove the screw (6) that secures the motor to the inside of the rear door.
7. Remove the motor from the rear door.
8. Inspect the output shaft sealing grommet (4). Discard the grommet if it is in poor condition.