Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the battery negative cable.
2. Remove the driver side front seat from the top of the seat riser (3). .
3. Insert a finger into the pull hole (2) near the back of the seat riser cover (1) and pull the cover upward gently and evenly to disengage the tabs that secure the edges of the cover to the top of the seat riser.




4. Remove the screws (1) securing the cube relay bracket and high current fuse bracket to the driver seat riser (2).
5. Remove the screws (1) securing the Fuse/Relay Block #2 to the driver seat riser (2).
6. Disconnect the Fuse/Relay Block #2 electrical connectors.
7. Remove the Fuse/Relay Block #2 from the seat riser.