Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the Fuse/Relay Block #2 into the driver seat riser (2).
2. Connect the Fuse/Relay Block #2 electrical connectors.
3. Install the screws (1) securing the Fuse/Relay Block #2 to the driver seat riser (2).
4. Install the screws (1) securing the cube relay bracket and high current fuse bracket to the driver seat riser (2).




5. Position the seat riser cover (1) over the seat riser (3). Gently and evenly bend the cover far enough to engage the tabs that secure the edges of the cover to the top of the seat riser.
6. Reinstall the driver side front seat onto the top of the seat riser. .
7. Reconnect the battery negative cable.