Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Connect fuse/relay block #1 backside wire harness connectors.
2. Insert the two posts integral to the upper edge of the fuse/relay block #1 (5) into the holes in the upper end of the mounting bracket behind the instrument panel.
3. Align the lower end of the fuse/relay block #1 with the two alignment posts integral to the lower end of the mounting bracket (4) on the dash panel.
4. Push the lower end of the fuse/relay block #1 forward over the alignment posts of the lower mounting bracket until the latch tab (3) on each side snaps back into place.
5. Reconnect the external wire harness connections to the BCM.
6. Reinstall the trim onto the left cowl side inner panel. .
7. Reconnect the battery negative cable.