Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.

1. Position the fuse block into the vehicle left of the steering column.
2. Install fuse block connections and connect all electrical connectors on the fuse block.
3. Push the fuse block housing forward to secure it to the Fuse/Relay Block #1 (also known as the SRB). Ensure the retaining tabs at the top of the fuse block housing that secure it to the SRB are fully seated.
4. Reinstall the trim onto the left cowl side inner panel. .
5. Reconnect the battery negative cable.