Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the battery negative cable.
2. Remove the left outboard air outlet bezel from the instrument panel. .
3. From the back of the air outlet bezel (4), compress the latch features on the headlamp leveling switch housing (3) and push the switch out through the face of the bezel.
4. Remove the headlamp leveling switch from the face of the air outlet bezel.