Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the Programmable Special Module (PSM) to the module mounting strip (3) within the driver side front seat riser (1).
2. Install and tighten the two screws that secure the PSM to the mounting strip. Tighten the screws securely.
3. Reconnect the vehicle wire harness connectors to the connector receptacles on the top of the PSM.
4. Position the module mounting strip (3) to the top of the inboard and outboard sides of the seat riser (1).
5. Install and tighten the three screws (2) that secure the module mounting strip to the seat riser. Tighten the screws securely.




6. Position the seat riser cover (1) over the seat riser (3). Gently and evenly bend the cover far enough to engage the tabs that secure the edges of the cover to the top of the seat riser.
7. Reinstall the driver side front seat onto the top of the seat riser. .
8. Reconnect the battery negative cable.
9. Using a diagnostic scan tool, perform PSM Initialization/Configuration through the scan tool "Misc. Func.'s" menu to match the vehicle accessory content.