Lamp/Switch

LAMP/SWITCH

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the glove box lamp and switch (2) into the instrument panel glove box opening (1).
2. Reconnect the vehicle wire harness connector to the connector receptacle on the top of the lamp housing.
3. Engage the switch plunger (3) through the plunger clearance hole in the instrument panel glove box opening.
4. Engage the rearward edge of the glove box lamp into the rearward edge of the mounting hole.
5. Pull the forward edge of the glove box lamp slightly rearward, then press it upward into the front of the mounting hole until it snaps into place.
6. Roll the glove box back up into place past the two integral stops (4) in the glove box opening, and restore the removed contents to the glove box.
7. Reconnect the battery negative cable.