Bulb - Van And Wagon

BULB - VAN AND WAGON





NOTE: The rear lamp unit contains up to five bulbs: brake lamp (2), park/tail/rear side marker (3), backup (4), turn signal (5) and, on the driver side only, a rear fog lamp (6). The service procedures for each bulb are the same, only the bulb sizes and types may differ.

1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit from the vehicle. .
3. Release each of the seven latch features (1) that secure the socket plate (7) to the back of the rear lamp unit housing.
4. Remove the socket plate from the lamp housing.
5. Push the ineffective bulb (2, 3, 4, 5 or 6) slightly toward the socket plate and rotate it counterclockwise about 30 degrees to unlock it.
6. Pull the base of the bulb straight out of the socket plate.