Installation

INSTALLATION

NOTE: Replacement of the O-ring seal is required anytime the A/C pressure transducer is removed. Failure to replace the rubber O-ring seal may result in a refrigerant system leak.





1. Lubricate a new O-ring seal with clean refrigerant oil and install it onto the fitting of the A/C pressure transducer (3). Use only the specified O-ring seal as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
2. Install the A/C pressure transducer into the tapping block (4) located at the left end of the A/C condenser (1). Tighten the A/C pressure to 10 Nm (88 in. lbs.).
3. Connect the wire harness connector (2) to the A/C pressure transducer.
4. Reconnect the negative battery cable.
5. Evacuate the refrigerant system .
6. Charge the refrigerant system .