Timing Chain Tensioning Rail

TIMING CHAIN TENSIONING RAIL





NOTE: Carefully clean all mating surfaces with appropriate solvents to assure that no grease or oil is present during reassembly.

1. Install tensioning rail on bearing pin
2. Install the timing chain tensioner retaining bolt. Tighten to 12 Nm (106 lbs. in.)
3. Install timing cover .
4. Install oil pan and bolts. Tighten M6 bolts to 9 Nm (80 lbs. in.) and M8 bolts to 20 Nm (15 lbs. ft.).
5. Install cylinder head .
6. Install the cylinder head covers.
7. Reconnect negative battery cable.

WARNING: Use extreme caution when the engine is operating. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothes.

8. Start the engine and inspect for leaks. Care must be taken to observe the fuel system warnings.