Rear

REAR

NOTE: The washer pump/motor unit can be removed from the washer reservoir without removing the reservoir from the vehicle.




1. Disconnect and isolate the battery negative cable.
2. Siphon the washer fluid from the washer reservoir (1) into a clean container for reuse.
3. Remove the two screws that secure the reservoir to the bracket on the top of the left front fender inner wheel house.
4. Lift the washer reservoir upward far enough to access the rear washer pump/motor unit (3) on the inboard side of the reservoir.
5. Disconnect the wire harness connector from the rear washer pump/motor unit.
6. Disconnect the washer supply hose from the barbed pump outlet nipple.
7. Grasp the top of the washer pump/motor housing and pull it firmly inboard far enough to disengage the snap fit between the motor housing and the molded motor receptacle in the reservoir.
8. Using hand pressure, firmly grasp and pull the washer pump upward far enough to disengage the pump inlet nipple from the rubber grommet seal/filter screen in the reservoir. Care must be taken not to damage the reservoir.
9. Remove the rubber grommet seal/filter screen from the pump mounting hole in the washer reservoir and discard.