Installation

INSTALLATION




1. Install strut (1) to the steering knuckle. Tighten lower bolts (2) to 140 Nm (103 ft. lbs.) Plus an additional 120� turn.




2. Raise the lower control to install the upper part of the strut into the foot well.
3. Install the wheel speed sensor wire to the routing clip.
4. Install the rear half of the wheel well liner.
5. Install wheels.
6. Lower the vehicle.




7. Install the upper strut mounting bolts (3). Tighten the bolts (3) to 28 Nm (21 ft. lbs.).
8. Install the floor pan and the screws (1) and the floor mat (2).
9. Perform a front wheel alignment.