Installation

INSTALLATION




1. Install the steering shaft (2) through the rubber grommet in the cab floor. Ensure that the rubber grommet is properly seated.




2. Install the steering shaft universal joint (1) onto the steering gear shaft all the way down until the hole lines up with the radial groove in the steering shaft onto the steering gear (3).




3. Install the bolts (5) in the steering shaft to the cab floor. Tighten to 21 Nm (15 ft. lbs.).
4. Install the fitted bolt (1) to the universal joint on the steering gear shaft (2). Tighten the bolt to 28 Nm (21 ft. lbs.).
5. Install the spring for the brake pedal to the steering column.
6. Reconnect the electrical connector to the ignition lock.
7. Install the combination switch.
8. Install the clockspring.
9. Install the steering wheel.
10. Install the electrical center.
11. Reconnect the ground cable to the battery.