Front Right - Passenger Bench Seat

FRONT RIGHT - PASSENGER BENCH SEAT

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler Mopar(R) Parts Catalog.




1. Lift and pull the front of the passenger side front bench seat cushion forward, then tilt the rear edge of the cushion forward to access the storage area and the lower anchor of the right seat belt buckle (1) below the seat cushion.
2. Remove the screw (2) that secures the buckle lower anchor to the center of the seat back frame.
3. Remove the buckle and the spacer from the center of the seat back frame.