Removal

REMOVAL




1. Disconnect negative battery cable.
2. Raise and support the vehicle.
3. Remove both front lower splash shields.




4. Remove the transmission thermal bypass valve and the cooler lines between the block and transmission.




5. Remove the starter blank.
6. Install # 9102 flywheel locking tool.




7. Release the accessory drive belt tension by resetting the drive belt tensioner and installing a retaining pin.




8. Remove the vibration damper bolt.
9. Install special tool #9544 (1) vibration damper puller.
10. Remove the vibration damper (2).

CAUTION: Care must be taken when removing the crankshaft seal. DO NOT damage or gouge the timing chain cover.

11. Using suitable seal puller, remove the front crankshaft seal.