Installation

INSTALLATION





NOTE: To prevent potential oil leaks, DO NOT touch the front crankshaft inner seal. Always handle the seal from the outer diameter.

1. Clean timing chain cover (1) seal surface.

NOTE: Keep seal centered in the timing chain cover at all times.

2. Install crankshaft oil seal (2) using Installer 8936A.
3. Align the alignment key in the crankshaft with the key way in the damper and install the vibration damper. Torque bolt to 304 Nm, plus 90� (224 ft.lbs., plus 90�).




4. Position the drive belt back onto the pulleys and release the belt tensioner.




5. Remove #`9102 flywheel locking tool..




6. Install the transmission thermal bypass valve (2) and transmission cooler lines (1).




7. Install the intermediate (2) and front (1) underbody splash shields.
8. Lower the vehicle.
9. Connect negative battery cable.