Left

LEFT




1. Disconnect negative battery cable.
2. Remove the engine cover (3) and bracket.
3. Remove the strut tower support (2).




4. Disconnect the fuel tank supply (1) and return lines (1) from the fuel line bundle.
5. Separate the rear engine wiring harness (2) and hold downs at cylinder head cover.




6. Separate the fuel supply line at the high pressure pump and fuel filter.
7. Remove the high pressure fuel line from the high pressure pump to the fuel rail.�




8. Remove the high pressure lines from the fuel rail to fuel injectors.
9. Disconnect the fuel injector electrical connectors.
10. Remove the oil filter housing to engine cover bracket.
11. Lift up on the center of the return fuel line connector and separate the return fuel hose from fuel injectors.
12. Remove the fuel rail (2).




13. Remove the engine harness retainers and fasteners (2).
14. Remove the EGR valve (1).




15. Remove the fuel injectors (1).
16. Remove the power brake booster hose and set aside.
17. Remove the cylinder head cover (2) fasteners, note the different size fasteners for assembly.

CAUTION: Care must be taken not to damage the cylinder head cover. If the sealant is difficult to separate, use a hand held heat gun and warm the area thoroughly along the sealer bead.

18. Remove the cylinder head cover (2).




19. Remove the front camshaft oil seal (2).�




20. Remove the left rear camshaft oil seal (2).