Temperature Control

REMOVAL

WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.

NOTE: The rear A/C temperature control is used only on models with the optional rear A/C unit.

1. Disconnect and isolate the negative battery cable.
2. Remove the accessory switch panel from the instrument panel.

Rear A/C Temperature Control:

3. Disconnect the wire harness connector from the rear A/C temperature control.
4. Disengage the retaining tabs and remove the rear A/C temperature control from the accessory switch panel.

INSTALLATION
1. Install the rear A/C temperature control into the accessory switch panel. Make sure the retaining tabs are fully engaged.
2. Connect the wire harness connector to the rear A/C temperature control.
3. Install the accessory switch panel.
4. Reconnect the negative battery cable.