Rear

REAR BLOWER MOTOR SWITCH

REMOVAL

WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.

NOTE: The rear A/C blower motor switch is used on vehicles with the optional rear A/C system.

1. Disconnect and isolate the negative battery cable.
2. Remove the accessory switch panel from the instrument panel.

Rear A/C Blower Motor Switch:

3. Disconnect the wire harness connector from the rear A/C blower motor switch.
4. Disengage the retaining tabs and remove the rear A/C blower motor switch from the accessory switch panel.

INSTALLATION
1. Install the rear A/C blower motor switch into the accessory switch panel. Make sure the retaining tabs are fully engaged.
2. Connect the wire harness connector to the rear A/C blower motor switch.
3. Install the accessory switch panel.
4. Reconnect the negative battery cable