Starter Relay: Service and Repair

STARTER MOTOR RELAY

Fuse/Relay Block:

The starter relay is located in the Fuse/Relay Block. The Fuse/Relay Block is located under, and to the left side of the drivers seat. See Fuse/Relay Block cover for relay identification and location.

REMOVAL

Fuse/Relay Block Cover:

1. Remove Fuse/Relay Block cover by pushing down on two tabs located at top of cover.
2. Remove relay from Fuse/Relay Block.
3. Check condition of relay terminals and Fuse/ Relay Block connector terminals for damage or corrosion. Repair if necessary before installing relay.
4. Check for pin height (pin height should be the same for all terminals within the Fuse/Relay Block connector). Repair if necessary before installing relay.

INSTALLATION
1. Install relay into Fuse/Relay Block.
2. Install cover to side of Fuse/Relay Block (snaps on).