Service Procedure

1. Disconnect and isolate the negative battery cable.





2. Locate the center and rear dome lamps on the rear A/C overhead console (Figure 1).





3. Insert the tip of a small flat-bladed screwdriver into the notch on one edge of the center dome lamp housing (Figure 2). Depress the retainer clip and pull that edge of the lamp away from its mounting location.





4. Pull the dome lamp unit from its mounting location far enough to access and disconnect the vehicle wire harness electrical connector from the dome lamp electrical connector receptacle (Figure 3).

5. Remove and discard the original dome lamp assembly.

6. Insert the two bulbs provided into the new dome/reading lamp assembly.

7. Reconnect the vehicle wire harness electrical connector to the new dome/reading lamp electrical connector receptacle (Figure 3).

8. Position the edge of the new dome/reading lamp housing opposite from the retainer clip into the mounting hole.

9. Push firmly and evenly on the notched edge of the new dome/reading lamp housing until the retainer clip latches into place.

10. Repeat steps 2 through 9 on the rear dome lamp.

11. Connect the negative battery cable.