Maintenance Required Lamp/Indicator: Service and Repair

ASSYST MAINTENANCE COMPUTER - RESET

The counter can also be reset by any individual after the indicated service has been performed. To do so:

1. Turn key to the ON/RUN position.

2. Within one second press the knob/button (mi/km) twice.

3. The present status for days or distance is displayed. Within 10 seconds turn the key to OFF/LOCK.

4. Press and hold the knob/button (mi/km), while turning the key to ON/RUN again. The present status for days or distance is displayed once more. Continue to hold the knob/button (mi/km).

5. After approximately 10 seconds, a signal sounds and the display shows 7,000 miles for approximately 10 seconds.

6. Release the knob/button (mi/km).

If the counter was inadvertently reset, have an authorized dealer correct it.

The message is displayed for approximately 10 seconds when turning the key to the ON/RUN position, or while driving when reaching the service warning threshold. It can be canceled manually by pressing the knob/button (mi/km).

Once the suggested term has passed, the message plus either the symbol for Service A or the symbol for Service B preceded by a - (minus symbol) blinks for approximately 30 seconds and a signal sounds every time when turning the key to the ON/RUN position.

The display can also be called up for approximately 10 seconds with the display illuminated by pressing the knob/buffon (mi/km) twice within one second.

Following a completed A or B service your authorized dealer sets the counter to 7,000 miles