Exhaust Tube

REMOVAL

WARNING: THERE IS A POTENTIAL DANGER OF SKIN BURNS AS THE SUPPLEMENTAL CABIN HEATER UNIT AND ITS COMPONENTS CAN BECOME VERY HOT. MAKE SURE THE HEATER UNIT IS ALLOWED TO COOL DOWN BEFORE ANY SERVICE WORK ON THE CABIN HEATER SYSTEM IS ATTEMPTED. FAILURE TO OBSERVE THIS WARNING MAY RESULT IN POSSIBLE PERSONAL INJURY.

1. Raise and support the vehicle while taking note of the location of the flexible exhaust tube section.

Cabin Heater Exhaust System:

2. Remove the exhaust clamp at the flexible pipe and steel pipe connection.
3. Remove the clamp at the flexible pipe connection and the supplemental heater housing (if required).
4. Remove the three screws holding the exhaust pipe to the body.
5. Remove the steel exhaust pipe from the vehicle.
6. Remove the flexible exhaust pipe from the vehicle (if required).

INSTALLATION
1. Install the flexible exhaust pipe to the heater unit. Tighten mounting clamp securely.
2. Position the steel exhaust pipe to the flexible exhaust and install and tighten the mounting clamp securely.
3. Install the three exhaust pipe screws, adjust pipe placement as needed and tighten the screws securely.
4. Install the clamp to connect the steel exhaust pipe to the flexible exhaust pipe and tighten clamp securely.
5. Check exhaust pipe exhaust end placement and make any final adjustments.
6. Lower the vehicle.