Air Cleaner Housing: Service and Repair
AIR CLEANER HOUSINGREMOVAL
1. Disconnect the negative battery cable.
2. Remove the heat shield.
3. Remove the air flow sensor.
4. Disconnect the air intake pressure sensor, unclip the top of the air cleaner housing and remove (Fig. 11).
5. Take out air cleaner element (Fig. 11).
6. Detach bottom part of the air cleaner housing at the body (Fig. 11).
7. Take air intake hose out of inner fender and out of the rubber bushing in the wheel housing liner, then detach it at the bottom part of the air cleaner housing (Fig. 11).
8. Remove bottom portion of the air cleaner housing out of the rubber bushings in the inner fender and remove (Fig. 11).
INSTALLATION
NOTE: Ensure that the seal between the inner fender well and the air intake hose is correctly installed.
1. Seat and retain bottom portion of the air cleaner housing into the bushings on the inner fender (Fig. 11).
2. Install the air intake hose to the air cleaner housing the align and install it in the inner fender and wheel housing liner (Fig. 11).
3. Install air cleaner element (Fig. 11).
4. Install and clip air cleaner top to air cleaner body and connect the air intake pressure sensor (Fig. 11).
5. Install air flow sensor (Fig. 11).
6. Install heat shield.
7. Connect negative battery cable.