15" Wheels
BRAKE PADS/SHOES - REARREMOVAL (15" WHEELS) (SRW)
1. Unscrew the cap from the brake fluid reservoir.
2. Raise and support the vehicle.
3. Remove the rear wheels.
4. Remove the wear indicator cable and the wear indicator (Fig. 7).
NOTE: Seal off the line ends and connection threads in the brake calipers with plugs. Also check brake hoses for signs of cracks.
5. Remove the brake caliper guide pin (Fig. 7).
6. Fold the top section of the brake caliper up (Fig. 7).
7. Remove the pads (Fig. 7).
INSTALLATION (15" WHEELS) (SRW)
1. Install the brake pads (Fig. 7).
2. Install the wear indicator cable and the wear indicator (Fig. 7). Tighten to 10 Nm (89 inch lbs.).
NOTE: Do not install the brake hose twisted and ensure freedom of movement.
3. Install the brake caliper to brake caliper adapter (Fig. 7). Tighten the guide pin to 30 Nm (266 inch lbs.) for M10 bolt.
4. Install the rear wheels.
5. Lower the vehicle.