Service Procedure

1. Open the rear doors and inspect for black roof foam inserts located just behind the front seats near the roof (Figure 1).

If the roof foam inserts are present on both sides as shown in Figure 1, no further action is required. Return the vehicle to the customer.

If no roof foam inserts are present, roof foam inserts must be installed. Continue with Step 2 of this procedure.





2. Detach the door weather seal from the upper end of the A-pillar to the lower end of the B-pillar on the driver and passenger side door openings (Figure 2).

3. Move both front seats to the full forward position.





4. Detach the B-pillar trim panel from the B-pillar on the driver and passenger sides of the vehicle (Figure 3).

NOTE:
The seatbelt assembly does not require removal. Detach B-pillar trim panel and allow it to hang loosely in the seatbelt (Figure 3).





5. Detach the edge guard on left and right side of the partition wall attachment plate (Figure 4).

6. Using a trim stick, unclip the rear edge of the headliner along the roof bow.





7. While pulling the headliner down slightly, install the right and left side roof foam inserts as shown in Figure 5.

NOTE:
The roof foam inserts on the left-hand side must engage with the molded lug in the opening of the roof edge support.

8. Using a small screwdriver, carefully remove any headliner clips that may have remained in the roof bow.

9. Insert the headliner retaining clips removed in Step 8 into the recesses in the headliner.

NOTE:
Replace any damaged headliner retaining clips (P/N 05125569AA) if required.

10. Attach the rear edge of the headliner by snapping headliner clips into the roof bow.

NOTE:
The headliner clips must be installed onto the headliner prior to attaching the headliner to the roof bow.

11. Attach the edge guard onto the left and right partition wall attachment plate (Figure 4).

12. Remove any retaining clips that remained in the B-pillar and attach the clips to the lugs on the B-pillar trim panel.

13. Install the right and left side B-pillar trim panels (Figure 3).

14. Verify that the seat belt height adjusters function properly.

15. Install the door weather seal on driver and passenger side door penings (Figure 2).