30000 MI or 48000 KM

Inspect
    Wheels
      Inspect the wheels and related components for abnormal noise, wear, looseness or drag, if using special operating condition D. Inspect wheels and related components for abnormal noise, wear, loosness or drag.
    Vehicle
      Perform multi-point inspection
    Universal Joint, Drive/Propeller Shaft
      Inspect rear axle and U-joints; lubricate if equipped with grease fittings.
    Tie Rod End
    Tie Rod Boot
    Steering and Suspension
      Inspect steering linkage, ball joint, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
    Fluid - A/T
      Inspect automatic transmission fluid level (if equipped with dipstick).
    Exhaust System
      Inspect exhaust system and heat shields.
    Cooling System
      Inspect engine cooling system and motor/electronics cooling system stength and hoses.
    Constant Velocity Joint Boot
      Inspect half-shaft boots (if equipped).
    Brakes and Traction Control
      Inspect brake pads, shoes, rotors, drums, brake linings, hoses and parking brake.
    Ball Joint
Replace
    Oil Filter, Engine
       If using special operating condition D.
    Engine Oil
      Change engine oil and filter, if using special operating condition D. Change engine oil and filter.
    Cabin Air Filter / Purifier
      Replace cabin air filter, if using special operating condition I and/or D.
    Air Filter Element
      If using normal condition. Replace engine air filter, if using special operating condition I and/or D.
Rotate
    Tires
      Rotate tires, inspect tire wear and measure tread depth. Rotate tires, inspect tires for wear and measure tread depth, when using special condition D.