Engine - Rolling/Fast Idle, DTCs P0507, P0171, P0174
TSB 13-1-401/10/13
2.0L GTDI - ROLLING/FAST IDLE - DIAGNOSTIC
TROUBLE CODES (DTCS) P0507, P0171 AND/OR
P0174 - BUILT ON OR BEFORE 9/28/2012
FORD:
2013 Fusion, Escape
ISSUE
Some 2013 Escape and Fusion vehicles built on or before 9/28/2012 and equipped with the 2.0L gasoline turbo direction injection (GTDI) engine may exhibit a rolling/fast idle with DTCs P0507, P0171, and/or P0174. This may be due to a missing plug on the left hand side of the intake manifold.
ACTION
Follow the Service Procedure steps to correct the concern.
SERVICE PROCEDURE
1. Inspect the left hand side of the intake manifold for a missing plug. Is the plug missing from the intake manifold? (Figure 1)
a. Yes - proceed to Step 2.
b. No - this article does not apply. Perform normal diagnostics. Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual.
2. Install the intake manifold plug using the instruction sheet provided in the kit.
a. The kit includes the locking ring which typically remains in the intake manifold. Discard the new locking ring in kit. Do not attempt to remove or replace the locking ring as intake manifold damage will occur.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
OPERATION DESCRIPTION TIME
130104A 2013 Escape And Fusion 0.3 Hr.
2.OL GTDI: Check DTCs
Inspect And Install Intake
Manifold Plug Following Kit
Instruction (Do Not Use
With Any Other Labor
Operations)
DEALER CODING
CONDITION
BASIC PART NO. CODE
9424 24
Disclaimer