Camshaft Position Sensor: Service and Repair

Camshaft Position (CMP) Sensor - 3.5L GTDI





NOTE: Lower radiator hose removed for clarity.









Removal and Installation

Both sensors

1. Remove the Air Cleaner (ACL) outlet pipe and the ACL (Air Cleaner).

RH sensor

2. Position the RH turbocharger intake tube aside. For additional information, refer to Intake Air System Components- Exploded View in Fuel Delivery and Air Induction.

LH sensor

3. Position the LH turbocharger intake tube aside. For additional information, refer to Intake Air System Components- Exploded View in Fuel Delivery and Air Induction.

Both sensors

4. Disconnect the Camshaft Position (CMP) sensor electrical connector.

5. Remove the bolt and the CMP (Camshaft Position) sensor.
- To install, tighten to 10 Nm (89 lb-in).


6. NOTE: Lubricate the CMP (Camshaft Position) sensor O-ring seal with clean engine oil.
To install, reverse the removal procedure.