Seat Cushion Cover - Rear

Seat Cushion Cover - Rear

Removal and Installation

NOTE: For parts identification and location, refer to Seat - Exploded View, Second Row .

1. Remove the rear seat cushion. For additional information, refer to Seat Cushion- Rear Seat Cushion - Rear.

2. If equipped, route the heated seat jumper harness out of the cushion cover retainers on each side.

3. From underneath the cushion assembly, remove the hog rings retaining the cushion trim cover wires and draw strings to the cushion foam pad wires.
- At installation, route the heated seat mat wire harness under the draw string.


4. NOTICE: Use care when separating the cushion cover wires from the cushion foam pad clips, or the clips can be torn from the cushion foam pad.

Separate the cushion cover wires from the foam pad clips and remove the cover.


5. To install, reverse the removal procedure.