Lumbar Assembly - Manual

Lumbar Assembly - Manual

Removal

NOTE: For parts identification and location, refer to Seat - Exploded View, Front .

1. Remove the backrest. For additional information, refer to Seat Backrest- Front .

2. NOTE: Note wire harness routing for installation.
Disengage the backrest cover lower J-clips and route the wire harness out of the hole in the backrest cover.






3. On each side, separate the backrest cover clip and hook-and-loop strips.





4. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest cover up to the first backrest cover wire.


5. Remove the manual lumbar.
1. Disengage the cable.

2. Disengage the manual lumbar retainers.






6. NOTICE: Do not let metal shavings get into the seat track. Failure to follow this instruction can result in seat track damage and failure.

Remove the rivets and the manual lumbar control.


Installation

1. Position the manual lumbar control and install new rivets.

2. Engage the manual lumbar retaining clips and cable retainer.

3. Roll the backrest cover down and attach the hook-and-loop strips.

4. Route the wire harness through the hole in the backrest cover and engage the lower J-clips.
- Make sure the manual lumbar cable is routed out from the outboard side of the backrest cover before engaging the lower J-clips.






5. On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.





6. Install the seat backrest. For additional information, refer to Seat Backrest- Front .