Bumper - Front

Bumper - Front

Removal and Installation

1. Remove the front bumper cover. For additional information, refer to Bumper Cover- Front Service and Repair.

2. Remove the ambient air temperature sensor from the front bumper, if equipped.





3. Remove the radiator air deflector lower pin-type retainer.





4. NOTE: There are 2 tack welds on each side of the front bumper. These welds must be drilled out to remove the beam.

If equipped, drill out the 2 tack welds on each side of the front bumper.






5. Remove the front bumper bolts.
- To install, tighten to 23 Nm (17 lb-ft).


6. Remove the front bumper.

7. NOTE: Tack welds retaining the front bumper to the body rails are not required for installation. Install new front bumper bolts.
To install, reverse the removal procedure.