Pinpoint Test AP: The Turn Signal On Warning Chime Is Inoperative

Instrumentation, Message Center and Warning Chimes

Pinpoint Test AP: The Turn Signal On Warning Chime Is Inoperative

Normal Operation

The turn signal on warning chime sounds when the vehicle travels more than 3.2 km (2.0 miles) with the turn signal on. The Smart Junction Box (SJB) communicates the turn signal switch status to the Instrument Panel Cluster (IPC) over the Medium Speed Controller Area Network (MS-CAN). The IPC (Instrument Panel Cluster) receives the odometer rolling count data from the PCM over the High Speed Controller Area Network (HS-CAN).

This pinpoint test is intended to diagnose the following:

- Odometer operation

- IPC (Instrument Panel Cluster)

PINPOINT TEST AP : THE TURN SIGNAL ON WARNING CHIME IS INOPERATIVE

AP1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

- Ignition OFF.

- Ignition ON.

- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

Does the safety belt warning chime operate for approximately 6 seconds?

Yes
GO to AP2.

No
INSTALL a new IPC (Instrument Panel Cluster). REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation.

AP2 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION

- Ignition OFF.

- Insert the key into the ignition lock cylinder.

- Open the LH front door and observe the key-in-ignition warning chime operation.

Does the key-in-ignition warning chime work correctly?

Yes
GO to AP3.

No
GO to Pinpoint Test AK Pinpoint Test AK: The Key-In-Ignition Warning Chime Is Inoperative.

AP3 CHECK THE TURN SIGNAL INDICATORS OPERATION

- Ignition ON.

- Verify the turn signal indicators operation.

Do the turn signal indicators operate correctly?

Yes
GO to AP4.

No
GO to Pinpoint Test Z Pinpoint Test Z: The LH/RH Turn Indicator Is Never/Always On.

AP4 CHECK THE ODOMETER FOR CORRECT OPERATION

- Drive the vehicle and observe the odometer for correct operation.

Does the odometer operate correctly?

Yes
INSTALL a new IPC (Instrument Panel Cluster). REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation

No
GO to Pinpoint Test L Pinpoint Test L: The Odometer Is Inoperative.