Pinpoint Test X: The Safety Belt Warning Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Test X: The Safety Belt Warning Indicator Is Never/Always On

Normal Operation

The Restraints Control Module (RCM) monitors the safety belt position through the safety belt buckle switch. The RCM (Restraints Control Module) provides the safety belt buckle status to the Instrument Panel Cluster (IPC) over the High Speed Controller Area Network (HS-CAN) communication bus.

If the safety belt status message is missing for less than 5 seconds, the safety belt warning indicator remains in the last indication mode (on or off) based upon the last known good message received. If the safety belt status message is missing for 5 seconds or more, the IPC (Instrument Panel Cluster) sets DTC U0151:00 and defaults the safety belt warning indicator off.

This pinpoint test is intended to diagnose the following:

- RCM (Restraints Control Module)

- IPC (Instrument Panel Cluster)

PINPOINT TEST X : THE SAFETY BELT WARNING INDICATOR IS NEVER/ALWAYS ON

X1 CARRY OUT THE IPC (Instrument Panel Cluster) INDICATOR LAMP CONTROL ACTIVE COMMAND USING THE SCAN TOOL

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: IPC (Instrument Panel Cluster) DataLogger.

- Select the IPC (Instrument Panel Cluster) safety belt warning indicator (SBLT_LAMP) active command. Command the safety belt warning indicator on and off while observing the safety belt warning indicator.

Does the safety belt warning indicator illuminate when commanded on, and turn off when commanded off?

Yes
GO to X2.

No
INSTALL a new IPC (Instrument Panel Cluster). REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation.

X2 RETRIEVE THE RECORDED DTCs FROM THE IPC (Instrument Panel Cluster) SELF-TEST

- Check for recorded DTCs from the IPC (Instrument Panel Cluster) self-test.

Is DTC U0151:00 recorded?

Yes
GO to Pinpoint Test BN. Pinpoint Test BN: DTC U0151:00

No
GO to X3.

X3 RETRIEVE THE RECORDED DTCs FROM THE RCM (Restraints Control Module) SELF-TEST

- Check for recorded DTCs from the RCM (Restraints Control Module) self-test.

Are any DTCs recorded?

Yes
REFER to Restraints and Safety Systems &/or Air Bag Systems.

No
INSTALL a new RCM (Restraints Control Module). TEST the system for normal operation.