B0050:13
Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS)
Refer to Wiring Diagram Set 46 for schematic and connector information. [1][2]Diagrams By Number
Pinpoint Test - Supplemental Restraint System (SRS)
Pinpoint Test K: DTCs B0050:11, B0050:12, B0050:13 and B0050:1D
Refer to Wiring Diagram Set 46, Supplemental Restraint System for schematic and connector information. [1][2]Diagrams By Number
Normal Operation
The Restraints Control Module (RCM) monitors the driver safety belt buckle switch and circuits for the following faults:
- Open circuit
- Short to voltage
- Short to ground
- Current out of range
- Faulted driver safety belt buckle switch
If a fault is detected, the RCM (Restraints Control Module) will store DTC B0050:11, B0050:12, B0050:13 or B0050:1D in memory and will send a message to the Instrument Panel Cluster (IPC) to illuminate the air bag warning indicator.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Driver safety belt buckle switch
- RCM (Restraints Control Module)