Clutch Motor - 2

Clutch Motor - 2

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Material(s)






Removal

1. Clean the area around the clutch motor to make sure no debris gets into the clutch motor pocket.

2. Disconnect the clutch motor electrical connector.





3. Remove the 4 clutch motor bolts and the clutch motor.





Installation

1. Inspect the clutch motor pocket for damage or debris. Clean or repair as needed.





2. Apply High Temperature Nickel Anti-Seize Lubricant to the clutch motor surfaces as shown.





3. Apply High Temperature Nickel Anti-Seize Lubricant to the clutch actuator lever splines as shown.





4. NOTE: Clutch motor 2 splines may need to be turned to ease installation.

Install clutch motor 2 and the 4 clutch motor 2 bolts.
- Tighten to 11 Nm (97 lb-in).





5. Connect the clutch motor 2 electrical connector.