FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

150000 MI or 240000 KM

Inspect
    Wheels
      Inspect wheels and related components for abnormal noise, wear, looseness, or drag if using Special Operating conditions D, O.
    Vehicle
      Recommended multi-point inspection
    Universal Joint, Drive/Propeller Shaft
      Inspect and lubricate (if equipped with zerk fittings). If using Special Operating Conditions T, I and D, O
    Steering and Suspension
      Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
    Exhaust System
      Inspect exhaust system and heat shields.
    Cooling System
      Inspect engine cooling system for strength, and hoses.
    Constant Velocity Joint Boot
      Inspect half-shaft boots (if equipped).
    Brakes and Traction Control
      Inspect brake pads, shoes, rotors, drums, brake linings, hoses and parking brake.
Replace
    Oil Filter, Engine
      If using Special Operating conditions T, I, D, O, E.
    Fluid Filter - A/T
      Change automatic transmission fluid filter (except for 6F35, 6F50, AWF-21, FNR5 and TorqShift transmissions). If not using Special Operating Conditions.
    Fluid - M/T
      If not using special operation conditions. Replace manual transmission fluid if using Special Operating Conditions D, and O.
    Fluid - A/T
      Change automatic transmission fluid (except for 6F35, 6F50, AWF-21, FNR5 and TorqShift transmissions). If not using special operating conditions.
    Engine Oil
      If using Special Operating conditions T, I, D, O, E.
    Drive Belt
      Replace drive belt(s) if not replaced within the last 100,000 miles (160,000 km).
    Cabin Air Filter / Purifier
      If using Special Operating Conditions D, I, O.
    Air Filter Element
      If not using special operating conditions. If using Special Operating Conditions D, I, O.
Rotate
    Tires
      Rotate tires, inspect tires for wear and measure tread depth if using Special Operating Conditions D, O.