Vacuum Brake Booster: Service and Repair

Brake Booster

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Exploded View










Removal

NOTE: Removal steps in this procedure may contain installation instructions.

1. Remove the brake master cylinder. REFER to Brake Master Cylinder .

2. Remove and discard the brake booster rod clevis-locking pin and the 4 brake booster nuts.
- To install, tighten the new nuts to 25 Nm (18 lb-ft).





3. Disconnect the brake booster vacuum hose and check valve





4. Remove the brake booster.





Installation

1. To install, reverse the removal procedure.