Head Restraint Guide Sleeve

Head Restraint Guide Sleeve


WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Special Tool(s)

General Equipment:






Removal

1. Remove the head restraints.

2. 60 percent seat backrest shown, full seat backrest similar.

1. General Equipment: Screwdriver






3. 40 percent seat backrest shown, full seat backrest similar.

1. General Equipment: Screwdriver






Installation

1. NOTE: Make sure the holes in the backrest cover and backrest foam pad are aligned to the holes in the backrest frame.






2. By hand, pull upward on the head restraint guide sleeves and make sure they are properly locked into the backrest frame holes. If either of the head restraint guide sleeves can be removed by hand, repeat the installation procedure. If the head restraint guide sleeve(s) can be removed again after installing a second time, install a new head restraint guide sleeve(s).

3.