Roof Opening Panel Alignment

Roof Opening Panel Alignment

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

General Procedure

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system or whenever:
- the roof opening panel motor has been removed from the roof opening panel system
- the roof opening panel glass has been removed from the roof opening panel system
- the roof opening panel assembly has been removed from the vehicle
- a new roof opening panel motor has been installed
- a new sliding glass panel has been installed
- a new roof opening panel assembly has been installed

REFER to Roof Opening Panel Motor Initialization Programming and Relearning.

1. Position the roof opening panel to the CLOSED position.

2. Position the roof opening panel shade assembly to the OPEN position.

3. Loosen the 4 roof opening panel glass screws.

4. Make sure the roof opening panel is centered in the roof opening. Adjust the roof opening panel glass height to specification.





5. Tighten the 4 roof opening panel glass screws.

- 4 Nm (35 lb-in)

6. Initialize the roof opening panel motor. For additional information, REFER to Roof Opening Panel Motor Initialization Programming and Relearning.