Pinpoint Test C: DTC U0155:00

Body Control Module (BCM)

Pinpoint Test C: DTC U0155:00

Normal Operation

- DTC U0155:00 (Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information)- sets in the Body Control Module (BCM) if data messages received from the Instrument Panel Cluster (IPC) are missing. For a complete list of all network messages, refer to Information Bus.

This pinpoint test is intended to diagnose the following:

- Communication network concern

- IPC (Instrument Panel Cluster)

- BCM (Body Control Module)

PINPOINT TEST C : DTC U0155:00

C1 VERIFY THE CUSTOMER CONCERN

- Ignition ON.

- Verify that there is an observable symptom present.

Is an observable symptom present?

Yes
GO to C2.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

C2 CHECK THE COMMUNICATION NETWORK

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: Network Test.

- Carry out the network test.

Does the IPC (Instrument Panel Cluster) pass the network test?

Yes
GO to C3.

No
REFER to Information Bus, The Instrument Panel Cluster (IPC) Does Not Respond To The Scan Tool Pinpoint Test C: The Instrument Panel Cluster (IPC) Does Not Respond To The Scan Tool.

C3 RETRIEVE THE RECORDED DTCs FROM THE BCM (Body Control Module) SELF-TEST

- Check for recorded BCM (Body Control Module) DTCs from the self-test.

Is DTC U3003:16 or DTC U3003:17 recorded?

Yes
For DTC U3003:16, GO to Pinpoint Test F Pinpoint Test F: DTC U3003:16.

For DTC U3003:17, GO to Pinpoint Test G Pinpoint Test G: DTC U3003:17.

No
GO to C4.

C4 CHECK FOR DTC U3006:16 FROM THE IPC (Instrument Panel Cluster) SELF-TEST

- Retrieve the continuous memory DTCs from the IPC (Instrument Panel Cluster).

Is DTC U3006:16 recorded?

Yes
REFER to Instrument Panel, Gauges and Warning Indicators.

No
GO to C5.

C5 RECHECK THE BCM (Body Control Module) DTCs

NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI (Programmable Module Installation) may not have been carried out.

- Clear the DTCs. Repeat the BCM (Body Control Module) self-test.

Is DTC U0155:00 still present?

Yes
GO to C6.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

C6 CHECK FOR DTC U0155:00 or U0155 SET IN OTHER MODULES

- Clear the DTCs.

- Ignition OFF.

- Ignition ON.

- Wait 10 seconds.

- Enter the following diagnostic mode on the scan tool: Self-Test.

- Retrieve the continuous memory DTCs from all modules.

Is DTC U0155:00 or DTC U0155 set in any other module?

Yes
INSTALL a new IPC (Instrument Panel Cluster). CLEAR the DTCs. REPEAT the BCM (Body Control Module) self-test.

No
INSTALL a new BCM (Body Control Module). REFER to Body Control Module (BCM) Body Control Module (BCM). TEST the system for normal operation.