Cylinder Head Assembly
Cylinder HeadInstall a new gasket, the RH cylinder head and 8 new bolts. Tighten in the sequence shown in 5 stages:
Stage 1: Tighten to 20 Nm (177 lb-in).
Stage 2: Tighten to 35 Nm (26 lb-ft).
Stage 3: Tighten 90 degrees.
Stage 4: Tighten 90 degrees.
Stage 5: Tighten 90 degrees.
Install the M6 bolt.
Tighten to 10 Nm (89 lb-in).
Install a new gasket, the LH cylinder head and 8 new bolts. Tighten in the sequence shown in 5 stages:
Stage 1: Tighten to 20 Nm (177 lb-in).
Stage 2: Tighten to 35 Nm (26 lb-ft).
Stage 3: Tighten 90 degrees.
Stage 4: Tighten 90 degrees.
Stage 5: Tighten 90 degrees.
Install the M6 bolt.
Tighten to 10 Nm (89 lb-in).
Bolt re-usability
NOTE: The cylinder head bolts must be discarded and new bolts must be installed. They are a torque-to-yield design and cannot be reused.
Surface Variation -- Head-to-block, Head-to-manifolds And Surface Variation -- Warpage
Camshaft Bearing Cap
Install the 8 RH camshaft caps and the 16 bolts.
Tighten in the sequence shown to 10 Nm (89 lb-in).
Install the 8 LH camshaft caps and the 16 bolts.
Tighten in the sequence shown to 10 Nm (89 lb-in).
Intake Manifold Specifications
Exhaust Manifold Specifications
Camshaft Gear/Sprocket Specifications