Seat Occupant Classification Module - Air Bag: Service and Repair

Occupant Classification System Module (OCSM)

NOTE: This procedure only applies to seats equipped with Occupant Classification Sensor (OCS) weight sensor bolts.











Removal

WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Turn the ignition OFF and wait one minute.

2. Raise the seat to its highest position.

3. Disconnect the Occupant Classification System Module (OCSM) electrical connector.

4. Remove the 2 screws and OCSM.

5. To install, reverse the removal procedure.
- Carry out OCS system reset. For additional information, refer to Occupant Classification Sensor (OCS) System Reset Programming and Relearning.