Memory Set Switch

Memory Set Switch

Removal and Installation

10-way power seat

1. Pry the bezel up from the cushion side shield, disconnect the electrical connector, release the tabs and remove the memory SET switch.





14-way power seat

2. Slide up and remove the cushion side shield cover.





3. Remove the bolt and separate the safety belt anchor.
- Tighten to 48 Nm (35 lb-ft).

4. At the rear of the seat, detach the carpet flap toe-kick retainers from under the seat.





5. From the front of the seat, detach the wire harness retainer and disconnect the seat control switch electrical connectors.





6. Remove the cushion side shield.

1. Remove the screw at the back.

2. Remove the scrivet at the back.

3. Remove the screw at the front.

4. Pull out and release 3 retaining clips.

5. Slide down and separate the hook.

6. Disconnect the memory SET switch electrical connector.





7. Disengage the clips and remove the memory SET switch.

All seats

8. To install, reverse the removal procedure.