Blind Spot Module: Service and Repair

Side Obstacle Detection (SOD) Module

NOTE: Rear bumper cover removed for clarity.

NOTE: Left rear quarter panel shown, right side similar.











Removal and Installation

1. NOTE: Module configuration is required when a new Side Obstacle Detection Control Module - Left (SOD-L) or
Side Obstacle Detection Control Module - Right (SOD-R) is being installed. Upload the SOD-L or SOD-R module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programming and Relearning

2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

3. Remove the 4 rear fender splash shield screws. For additional information, refer to Bumper.

4. Remove the rear bumper cover screw and gently flex it to access the SOD-L or SOD-R.
- Remove the screw and washer.

- Disconnect the electrical connector.

5. Remove the SOD-L or the SOD-R.

6. If removing the bracket, remove the 2 screws and bracket.

7. To install, reverse the removal procedure.
- Download the SOD-L or the SOD-R configuration information. For additional information, refer to Information Bus.

- NOTE: When enabling the Blind Spot Information System (BLIS(TM)) and Cross Traffic Alert (CTA) system make sure to enable the systems in both the SOD-L and the SOD-R. Failure to do so will result in a mismatch system fault.

Verify in the programmable parameters that the Blind Spot Information System (BLIS(TM)) and Cross Traffic Alert (CTA) system are enabled in the SOD-L and SOD-R.

- After the SOD-L or the SOD-R is configured, shift the selector lever though all the transaxle gear positions (PRNDL).