T5OD

Transmission Rear Support Insulator

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the 2 transmission rear support insulator nuts.
- To install, tighten to 70 Nm (52 lb-ft).





3. Remove the transmission crossmember. For additional information, refer to Frame.

4. Remove the transmission rear support insulator center bolt and separate the transmission rear support insulator from the transmission.
- To install, tighten to 70 Nm (52 lb-ft).

5. To install, reverse the removal procedure.