Seat Control Switch

Seat Control Switch

Removal

NOTE: For parts identification and location, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the clip and recline handle.
- Access the clip from between the cushion cover and side shield.

2. NOTICE: Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become damaged during removal and may not remain attached if reinstalled. Install a new side shield during seat assembly.

Remove and discard the cushion side shield.

- Remove the screw at the rear of the cushion side shield.

- Separate the side shield and retainers from the seat.

- Remove the seat control switch.
- Disconnect the electrical connector.

- Remove the knob.

- Remove the switch from the side shield.

- If equipped, remove the power lumbar switch.
- Disconnect the electrical connector.

- Remove the switch from the side shield.

- Remove and discard the cushion side shield.

- Remove any remaining retainers from the seat and discard.

Installation

1. Install a new cushion side shield.
- Install the seat control switch.
- Install the switch into the side shield.

- Install the knob.

- Connect the electrical connector.

- If equipped, install the power lumbar switch.
- Install the switch into the side shield.

- Connect the electrical connector.

- Make sure all the side shield retainers are attached to the side shield.

- Install the side shield and screw to the seat.

2. Install the recline handle and clip.